TERMA ONE Série Mode D'emploi page 4

4. Install the electric dryer so that the lowest tube is at
least 600 mm above the floor.
5. The electric installation to which the heater is perma-
nently connected must have the right current differen-
tial and overcurrent relay (R.C.D.) of 30 mA. An Omni-
pole cut-out is required for disconnecting the device on
all poles, via joints positioned at least 3 mm apart.
6. The device is suitable for connection in zone 3 of a bath-
room, as defined by applicable regulations, unless oth-
erwise specified by regulations applicable in the coun-
try of installation and use.
Attention: the device must be installed out of reach of
persons in the bathtub, shower or pool.
4
User manual — ONE