Ibiza Light COMBILED20 Manuel D'utilisation page 2

EN
COMBINED LIGHT EFFECT ASTRO-STROBO-GOBO BEAM 3-IN-1
Safety Recommendations
• Please read the instructions carefully. They contain important information about the installation, operation and
maintenance.
• Keep this User Manual for future reference. If you sell the unit to another user, be sure that he also receives this
instruction booklet.
• Unpack and check the unit carefully that it has not been damaged during transport before using the unit.
• Before operating, ensure that the voltage and frequency of power supply match the power requirements of the
unit.
• The unit is for indoor use only in a dry location.
• The unit must be installed in a location with adequate ventilation, at least 0.5m from adjacent surfaces. Be sure
that no ventilation slots are blocked.
• Disconnect mains power before fuse replacement or servicing.
• Make sure there are no inflammable materials close to the unit during operation.
• In the event of serious operating problem, stop using the unit immediately.
• The light sources of the light effects are not replaceable. If a light source is faulty, the light effect must be dis-
carded.
• Do not touch any wires during operation as high voltage might be causing electric shock.
• The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or
a similar qualified person.
• The product is for decorative purposes only and not suitable as a household room illumination.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
Operating Instructions:
1. Connect the supplied mains adaptor into a suitable outlet delivering a voltage of 100V-240V~50/60Hz.
2. When the unit is powered on, it will be running in program mode.
3. Press AUTO. The fixture will run in Auto Mode and the indicator will flash fast.
4. Press SOUND. The fixture will run in Sound Controlled Mode and the indicator will flash slowly.
Indicator Light
Remote Control
ON ON
OFF All OFF, Include Light off and Motor Rotate
Auto Auto Running the built-in program
Sound Sound control the built-in program
▶ Paused and held the running state, and then press to continue running.
+ In Auto Mode, to adjust the running speed.
In Sound Mode, to adjust the sound sensitive
— In Auto Mode, to adjust the running speed.
In Sound Mode, to adjust the sound sensitive
<< UP
>> DOWN
1-9 Choose the built-in program
2
MANUAL - COMBILED20
INSTRUCTIONS FOR USE
Fast Flash
Slow Flash
When choose the function, for example, in Auto mode,
choose 2, press << to 1, press >> to 3
©Copyright LOTRONIC 2019
Auto Mode
Sound Controlled Mode