Aux-In Mode; Manually Setting Clock - PERFECTPRO DIGITUBE Manuel De L'utilisateur

Bluetooth LED
The menu of the radio can be configured to Bluetooth LED.
1. Press the On/Off button to turn on the radio.
2. Press the MENU button, and then press the Tuning
3. Press the SELECT-INFO button; then press the Tuning
4. Press the SELECT-INFO button to enter the Bluetooth LED adjustment menu.
Press the Tuning or
5. buttons to select "on" (by default) in order to keep Bluetooth LED lightened when connected;
6. Or Press the Tuning or buttons to select "off" to turn off Bluetooth LED when Bluetooth connection has been
established.
7. Press the SELECT-INFO button to confirm your choice. The Bluetooth LED will be changed upon the latest selection.
17
or buttons until the display shows "System".
or button until the display shows "Bluetooth LED".

AUX-IN MODE

A 3.5mm stereo Aux-In socket is provided on the side behind the rubber cover, for connecting an external audio device such as MP3
player or CD player (Aux cable not included with this radio).
1. Connect an audio source to the AUX-IN socket.
2. Press the SOURCE button to select AUX input. Display will show "AUX IN".
3. Play the external player.
4. Adjust the VOLUME of both the radio and the player for comfortable listening.
5. After use, close the rubber cover to prevent moist or dust from entering into the sockets and radio.
Notes: Never use the Aux-In socket in rainy or moist conditions to prevent moist from entering the radio. Keep the rubber cover well
closed under these conditions.
The Auto-Power management function will be activated in AUX mode. If there is no signal* from the Aux-In socket for a period of
over 15 minutes, the DigiTube radio will automatically switch to standby mode. Pressing the On/Off button will wake up the unit.
* Also when the incoming signal from the external device is too low and cannot be detected for a period of over 15 minutes by the
Auto-Power management, the DigiTube radio will switch to standby mode.
To prevent this raise the output level of the external device enough to be detected.

MANUALLY SETTING CLOCK

The clock can only be manually set when the radio is in standby mode. If no buttons are pressed for 5 seconds, the radio will exit the
clock setup and the setting is cancelled.
1. Press the MENU button for about 3 seconds, and the display will show "CLOCK SET".
2. Press the SELECT-INFO button. The hour digits flash on the display.
3. Press the TUNING or
4. Press the SELECT-INFO button to confirm. The minute digits flash.
5. Press the TUNING or
buttons to set the hour
buttons to set the minute.
GB
G B
18