Husqvarna Zenoah GZ360 Manuel D'utilisation page 20

To cut trees and branches that are in
tension
1. Figure out which side of the tree or branch that is in
tension.
2. Figure out where the point of maximum tension is.
3. Examine which is the safest procedure to release the
tension.
Note: In some situations the only safe procedure is
to use a winch and not your product.
4. Keep a position where the tree or branch can not hit
you when the tension is released.
5. Make one or more cuts of sufficient depth necessary
to decrease the tension. Cut at or near the point of
maximum tension. Make the tree or branch break at
the point of maximum tension.
WARNING: Do not cut straight through a
tree or branch that is in tension.
WARNING: Be very careful when you
cut a tree that is in tension. There is a
risk that the tree moves quickly before or
after you cut it. Serious injury can occur
if you are in an incorrect position or if
you cut incorrectly.
6. If you must cut across tree/branch, make 2 to 3 cuts,
1 in. apart and with a depth of 2 in.
20
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
To use the product in cold weather
CAUTION: Snow and cold weather can
cause operation problems. Risk of too low
engine temperature or ice on the air filter
and the carburetor.
1. If the temperature is 0˚ or colder, loosen the screws
on the front handle and remove the front handle.
2. Remove the starter housing.
3. Replace the air guide plate with the air guide plate
that is for winter use. Part number: 584 89 40-01.
4. Remove the DF air guide plate from the black air
guide plate and attach it to the blue air guide plate.
5. Remove the air filter cover.
6. Move the blue grommet from the closed position to
the open position. Use a screwdriver.
321 - 006 - 08.11.2018