Brita P 1000 Mode D'emploi page 7

3.3 Step 3: Installing the BRITA 3-Way Water
Filter Dispenser
To install the BRITA 3-Way Water Filter Dispenser, firstly ensure you
have all the components required.
Please make sure that there is enough room for the P 1000
!
filter cartridge, the hoses and the BRITA electronic cartridge
exchange indicator under the sink.
WD 3010
1.
2.
3.
4.
5.
6.
7.
(fig. 5)
1. B RITA 3-Way Water Filter Dispenser
with 3 hoses
2. O -Ring
3. T hreaded Bolt
4. J oint (Is only necessary for installa-
tion of the dispenser if you directly
mount it onto your sink. If you
mount it onto your countertop-plate,
you do not necessarily need this
part. It helps stabilizing the tap at
your sink)
5. F lat Gasket
6. F lange
7 . H ex nut
WD 3020
1. 1. B RITA 3-Way Water Filter Dispenser
with 3 hoses
2. O -Ring
3. S hank
4. J oint (Is only necessary for installa-
tion of the dispenser if you directly
mount it onto your sink. If you
mount it onto your countertop-plate,
you do not necessarily need this
part. It helps stabilizing the tap at
2.
your sink)
5. F lat Gasket
3.
6. F lange
7 . H ex nut
4.
5.
6.
7.
(fig. 5)
WD 3030 and WD 3040
1. B RITA 3-Way Water Filter Dispenser
(design may differ) with 3 hoses
2. S hank
3. B ase
4. J oint (Is only necessary for installa-
tion of the dispenser if you directly
mount it onto your sink. If you
1.
mount it onto your countertop-plate,
you do not necessarily need this
part. It helps stabilizing the tap at
your sink)
2.
5. F lat Gasket
3.
6. F lange
7 . H ex nut
4.
5.
6.
7.
(fig. 5)
7
ENGLISH