Before You Begin; Before Starting; Ducting - Elica SUT950 Guide D'utilisation, D'entretien Et D'installation

The manufacturer declines all responsi­bility in
the event of failure to observe the instructions
given here for installation,
suitable operation
manufacturer further declines all responsibility
for injury due to negligence and the warranty of
the unit automatically expires due to impro­per
maintenance and/or installation.
If vented externally, 6" / 150mm round ducting
must be available for the hood through the
ceiling, in line with the cen­tral vertical axis
of the range hood.
This unit must have it's own ductwork. Do not
under any circumstances vent this unit into any
other ductwork or
building.
Furthermore, please read carefully all of the
following installation instructions.
< Use an exhausting pipe whose maxi­mum length
does not exceed 5 meters.
< Limit the no. of elbows in the piping, since
each elbow reduces the air capacity
of 1 linear meter. (Ex.: if you use no. 2 x 90 °
elbows, the length of piping
meters).
< Avoid abrupt direction changes.
< Use a 150/200 mm constant diameter pipe for
the whole length.
< Use piping approved by standards in force.
6

BEFORE YOU BEGIN

maintenance
of the product.

DUCTING

exhaust ducting in
must not exceed 3
BEFORE YOU BEGIN: It is advisable to test run
the range hood before installation.
and
BEFORE STARTING
The
document and ensure you
with the require<ments and limitations. These
units weigh approxi­mately 125lbs and therefore
require a minimum of two people to install.
Recommended height from cook top to underside of
hood = 30" for gas, 25" for electric.
Use the shortest
possible. Only
ducting is generally not permit­ted by code. Do
not use flexible metal ducting as the ridges of
the ducting cau­se severe air turbulence and
will signifi­cantly reduce the efficiency of any
the hood <THIS TYPE
EFFICIENCY BY 50%.
Vent hoods may
exhaust gases from fire<places, gas furnaces and
gas water heaters.
drawing these lethal ga­ses back into the home
please follow
manufacturers safety standards and guidelines.
Refer to NFPA
information.
– please read this
are fully conversant
most direct ductwork
use metal ducting
OF DUCTING WILL
interrupt the proper
To mini­mize the
the heating
and ASHRAE for
en­tire
route
< plastic
REDUCE
flow of
risk of
equipment
additional