SUT950 - SUT951
Remote control
A:
At
every
selected
ghts on accordingly.
B:
To increase the speed.
C:
To switch on the lights or to switch
off.
D:
ON/OFF To go from a higher speed
first one press twice the but
the hood on or off
E:
To reduce the speed.
F:
To set the timer.
fig. 4
The led on the right side will start (every 5
seconds), the hood will work for 10 minutes at
the
selected
speed
automatically off. If the client increases or
reduced the speed while the timer is on, this
is automatically stopped.
function,
the
led
back to
ton: To switch
press once this button.
and
then
it
TECHNICAL DATA:
Alkaline battery powered: 12v mod. 23A
Operating frequency:
li
Combinations:
Max. consumption:
Operating temperature:
them
Standard configuration.
If two cooker hoods<radio control system are
installed in the same room or in the immediate
vicinity, each system may affect the operation
of the other, due to the fact that they have the
same code. Therefore it will be
change the code of one of the radio controls.
Generating a new transmission code.
The
radio
manufacturer with default codes stored. If you
want to create a new set of codes, proceed as
follows: press and hold the UP, STOP and DOWN
buttons simultaneously for 2 seconds. After the
LEDS light up, press the UP and DOWN buttons
within 5 seconds. The LEDS will flash 3 times to
indicate
that
WARNING: This procedure deletes all previously<
stored codes.
Learning the new transmission code.
After
changing
radio
control,
control unit must be made to set the new code as
follows: press the main Power Off button on the
cooker
hood
lights
electronic
seconds,
press
ensure the control unit is synchronized with the
new code.
433.92 Mhz
4096
25Ma
<20° : +55°C
control
is
supplied
the
process
the
transmission
the
cooker
and
then
restore
control
unit.
Within
the
Light
button.
necessary to
by
the
is
completed.
code
on
the
hood
electronic
power
to
the
the
next
15
This
will
11