WAGNER PAINT-N-ROLL PLUS Guide De Démarrage Rapide page 6

storagE
storagE notEs
Proper cleaning and lubrication of certain
i
components of the Paint-N-Roll Plus
are critical to prolonging the life of the
components.
If after extended use the plunger has a
tendency to stick, apply a generous amount
of petroleum jelly located on the end of the
plunger (see Lubricating the components,
step 2).
When storing the Paint-N-Roll Plus, make
sure the fill valve is pointing downward, and
never store the Paint-N-Roll Plus with the fill
tube inserted into the fill valve.
Attention
lubricatinG the componentS
1.
Turn the locking collar as shown until the main tube
slides easily off of the plunger.
2.
Lubricate around and in between the plunger O-rings
with petroleum jelly.
3.
Re-insert the plunger back inside the main tube. Make
sure the O-rings do not twist or cut.
4.
Tighten the locking collar.
5.
Lubricate the inside of the fill valve housing on the main
tube with petroleum jelly.
6.
Clean and lubricate with petroleum jelly the indicated
areas on the roller arm.
7.
Reassemble roller cover. Place back onto roller arm.
8.
Attach roller arm to head.
Connecting areas
6
Seal
O-ring
6
En
7
1
2
3
4
5
8