Getting Started; Before You Begin; Parts And Components - WAGNER PAINT-N-ROLL PLUS Guide De Démarrage Rapide

gEtting startEd

bEForE you bEgin

•
Make sure the type of paint you use can be
cleaned with either mineral spirits (for oil-
based paints) or a warm water and soap
solution (for latex paints).
•
It is a good idea to have drop cloths protecting
your floors and anything else in the room that
you do not want accidentally splattered with
paint.

partS and componentS

Roller cap
Roller cover
Roller core
fillinG the main tube
The Paint-N-Roll Plus™ should
i
come preassembled new, or
should already be assembled after
Cleanup during previous usage.
If the unit is not assembled,
follow
Components" steps on page 6.
1.
Apply a thin layer of petroleum jelly to the
fill tube. This will help the fill valve slide easily
off the fill tube.
2.
Clip fill tube to paint container.
3.
Press down and firmly hold the fill valve onto
the fill tube.
4.
Pull the plunger to draw the material into
the main tube. When the tube is full, you are
ready to begin using the Paint-N-Roll Plus.
2
En
Quick-release tabs
Fill valve
the "Lubricating
Attention
Roller arm assembly
Head
Main tube
1
the
3
Some oil-based paints require a
stronger cleaning solution than
mineral spirits and should not
be used with the Paint-N-Roll
Plus. Using a cleaning solution
stronger than mineral spirits may
cause damage to the Paint-N-Roll
Plus.
Check with your paint supplier to be
sure the oil-based paint you have
can be cleaned with mineral spirits.
Fill tube
Locking collar
2
4
Plunger