Switching On/Off - Hilti SIW 22T-A Mode D'emploi

7.1.1.2 Removing the socket
1. Set the forward / reverse switch to the middle position or
remove the battery from the power tool.
2. Pull the socket away from the square drive spindle.
en
7.1.2 Changing the socket (¾" square drive with locking
pin)
7.1.2.1 Fitting the socket
1. Set the forward / reverse switch to the middle position or
remove the battery from the power tool.
2. Remove the O-ring from the groove in the socket.
3. Pull out the locking pin.
4. Place the socket on the square drive spindle of the tool.
NOTE Take care to ensure that the holes in the square drive
spindle and socket, into which the locking pin is inserted, are
in alignment with each other.
5. To secure the socket, first insert the locking pin and then fit
the O-ring.
7.1.2.2 Removing the socket
1. Set the forward / reverse switch to the middle position or
remove the battery from the power tool.
2. Remove the O-ring from the groove in the socket.
3. Pull out the locking pin.
4. Remove the socket from the square drive spindle of the tool.
5. To secure the socket, first insert the locking pin and then fit
the O-ring.
7.2 Setting forward or reverse rotation
NOTE
The forward / reverse switch is used to select the direction of
rotation of the drive spindle. An interlock prevents switching
while the motor is running. The control switch is locked when the
forward / reverse switch is in the middle position. Push the forward
/ reverse switch to the right (as seen in the working direction) for
forward rotation. Push the forward / reverse switch to the left (as
seen in the working direction) for reverse rotation.
7.3 Switching on / off
The speed of the power tool can be controlled smoothly (increased
from minimum to maximum) by pressing the control switch gradu-
ally.
7.4 Screwdriving
WARNING
Ensure fastener and attachment will withstand the level of
torque generated by the tool. Excessive torque may overstress,
strip or damage the fastener/attachment and possibly lead to
personal injury.
Set the forward / reverse switch to the desired direction of rotation.
7.5 Reading the charge status LED display on Li­ion batter-
ies 8
NOTE
The charge status cannot be indicated while the power tool is in
operation. Indication is given (LED 1 blinks) only when the battery
is fully discharged or when it is too hot (temperature above 80°C).
The battery must then be inserted in the charger. If all 4 LEDs
blink, this indicates that the power tool has been overloaded or
has overheated.
The Li-ion battery features a charge status LED display. The charge
status is indicated by the LEDs on the battery during charging
(please refer to the section "Li-ion battery charge status"). When
the battery is at rest (not in use), its charge status is indicated
by the four LEDs on the battery for a time of three seconds after
pressing one of the battery release buttons.
7.6 Belt hook
CAUTION
Check that the belt hook is fitted securely before beginning
work.
10
Printed: 29.11.2013 | Doc-Nr: PUB / 5070699 / 000 / 03
5
9
4
6
7