Accessories - Hilti SIW 22T-A Mode D'emploi

2.2 Chuck
½" square drive with ball-notch retention
¾" square drive with locking pin
2.3 Switches
Control switch with electronic speed control
Forward / reverse selector switch with safety lock
2.4 The items supplied include (toolbox versions):
1 Power tool
1 Operating instructions
1 Hilti toolbox
2.5 The items supplied include (cardboard box versions):
1 Power tool
1 Operating instructions
2.6 Additional items required for operating the tool
B 22/2.6 Li­Ion or B 22⁄3.3 Li­Ion battery with C4⁄36­90, C4⁄36­350,
C 4/36, C 4/36­ACS or C 4/36­ACS TPS charger.
2.7 Li-ion battery charge status and overheating indicator
LEDs light con-
stantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
-
2.8 Power tool overloading and overheating indicator
The power tool is equipped with an electronic protection system
to prevent overloading and overheating. The power tool switches
itself off automatically in the event of overloading and overheating.
After releasing the control switch, the power tool may not restart
immediately when the switch is pressed again (while the power
tool is cooling down).
LEDs light constantly
-

3 Accessories

Designation
Socket
Charger for Li-ion batteries
Charger for Li-ion batteries
Charger for Li-ion batteries
Charger for Li-ion batteries
Charger for Li-ion batteries
Battery
Battery
Battery
Belt hook
Printed: 29.11.2013 | Doc-Nr: PUB / 5070699 / 000 / 03
LEDs blink
-
-
-
-
LED 1
LED 1
LEDs blink
LED 1, 2, 3, 4
Short designation
S-NSD and SV
C 4/36
C 4/36­ACS
C 4/36-ACS TPS
C 4/36­90
C 4/36­350
B 22/3.3 Li­Ion
B 22/2.6 Li­Ion
B 22/1.6 Li­Ion
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
Battery overheated
Power tool
status
Power tool over-
loaded or over-
heated
en
3