Hitachi Koki CR 14DSL Mode D'emploi page 14

English
Blade
Slit of plunger
Blade
Slit of plunger
(4) When you release the lever, the spring force will return
the lever to the correct position automatically. (Fig. 10)
Lever
(5) Pull the back of the saw blade two or three times by
hand and check that the blade is securely mounted.
When pulling the blade, you will know it is properly
mounted if it clicks and the lever moves slightly. (Fig.
11)
Blade
Lever
CAUTION:
When pulling the saw blade, be absolutely sure
to pull it from the back. Pulling other parts of the
blade will result in an injury.
14
Fig. 8
Fig. 9
Fig. 10
Fig. 11
2. Dismounting the blade
(1) Turn on and off the switching trigger several times
so that the lever can jump out of the front cover
completely. Thereafter, turn off the switch and
remove the battery. (Fig. 3)
CAUTION:
Be absolutely sure to keep the switch turned off
and the battery removed to prevent any accident.
(2) After you have pushed the lever in the direction of
the arrow mark shown in Fig. 7, turn the blade so it
faces downward. The blade should fall out by itself.
If the blade doesn't fall out, pull it out by hand.
CAUTION:
Never touch the saw blade immediately after use.
The metal is hot and can easily burn your skin.
WHEN THE BLADE IS BROKEN
Even when the saw blade is broken and remains
inside the small slit of the plunger, it should fall out
if you push the lever in the direction of the arrow
mark, and face the blade downward. If it doesn't fall
out itself, take it out using the procedures explained
below.
(1) If a part of the broken saw blade is sticking out of
the small slit of the plunger, pull out the protruding
part and take the blade out.
(2) If the broken saw blade is hidden inside the small
slit, hook the broken blade using a tip of another
saw blade and take it out. (Fig. 12)
Another blade
MAINTENANCE AND INSPECTION OF SAW BLADE
MOUNT
(1) After use, blow away sawdust, earth, sand, moisture,
etc., with air or brush them away with a brush, etc.,
to ensure that the blade mount can function smoothly.
(2) As shown in Fig. 13, carry out lubrication around
the blade holder on a periodic basis by use of cutting
fluid, etc.
Fig. 12