Stihl MF-MM Notice D'emploi page 11

Checking Position of Gearbox
WARNING
To reduce risk of injury from the
MultiTool rotating in the wrong direction,
check that position of gearbox is correct
and adjust if necessary.
The axle (1) must be below the shaft (2).
Direction of rotation (3) of MultiTool.
Adjusting Position of Gearbox
Loosen clamp screws on gearbox.
N
Turn the gearbox through 180°.
N
Line up the gearbox in the correct
N
position.
Tighten down the two clamp screws
N
on the gearbox in the following
sequence:
MF-MM
Tighten the first screw moderately.
–
Tighten the second screw
–
moderately.
Tighten down first screw firmly.
–
Tighten down second screw firmly.
–
NOTICE
It must not be possible to rotate the
gearbox on the drive tube.
Mounting the Dethatcher
NOTICE
Left-hand and right-hand dethatchers
are different.
The direction of rotation is marked with
arrows on the gearbox and flange. Make
sure both arrows point in the same
direction.
The spring tines may be damaged or
break if the direction of rotation is wrong.
5
Rotate the left-hand dethatcher (4)
N
on the shaft until it can be pushed
into position – check the direction of
rotation again (arrows).
Insert hitch pin (5) in hole in shaft
N
and snap it into position.
Mount the right-hand dethatcher in
N
the same way.
WARNING
Always mount both dethatchers.
English
4
9