Table des Matières
Publicité
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(2) 7/16" wrenches
(2) 1/2" wrenches
(2) 9/16" wrenches
(2) 3/4" wrenches or adjustable wrenches
Before assembling the aerator, lay out all the parts
and hardware as shown on previous pages.
CAUTION:
KNIVES ARE SHARP! EXERCISE
CAUTION AT ALL TIMES WHILE
ASSEMBLING AND USING THE
AERATOR.
1. Assemble a wheel bracket to the middle hole in the shaft
so that the hub of the bracket faces the short end of
the shaft. Fasten the bracket to the shaft using a 1/4" x
1-3/4" (B) hex bolt and a 1/4" nylock nut (K). Tighten.
See figure 1.
2. Pre-assemble a 3/8" x 1-1/4" hex bolt (C) and a 3/8"
nylock nut (I) to the smaller hole in the wheel bracket.
Insert the bolt from the hub side of the bracket. Do not
tighten till step 15. See figure 1.
SHORT END
3/8" x 1-1/4"
OF SHAFT
HEX BOLT (C)
1/4" x 1-3/4"
HEX BOLT (B)
3/8" NYLOCK
NUT (I)
FIGURE 1
POINTS OF AERATOR
1/4" NYLOCK
NUT (K)
ENGLISH
3. Push split plastic bearings (V) into both ends of all spool
assemblies. See figure 2.
SPLIT
BEARING (V)
FIGURE 2
4. Assemble a spool assembly, a 5.29" long spacer (S),
another spool assembly, a 1.00" long spacer (Q) and
a 3/4" flat washer (M) onto the short end of the shaft.
See figure 3.
3/4" FLAT
WASHER (M)
1.00" LONG
SPACER (Q)
FIGURE 3
4
SPLIT
BEARING (V)
5.29" LONG
SPACER (S)
SHORT END
Publicité
Table des Matières
