Rules For Safe Operation - Agri-Fab 45-01764 Notice D'utilisation

RULES FOR SAFE OPERATION

Preventing accidents is the responsibility of every equipment
operator. The following general safety precautions must be
fully understood and followed by every operator.
1. Do not at any time carry passengers in this cart. It is
designed for carrying materials only and not intended
to carry passengers.
2. Be careful on any grade (hill) and stay off of steep
grades.
3. Use caution when loading cart to avoid tipping.
4. Avoid large holes and ditches when transporting
loads.
Your Farm/Yard Cart carton contains a hardware package
with parts as shown in the chart below and in figure 1.
Contents of Hardware Pack: (See figure 1)
REF. QTY.
A 8 Screws, M6 X 50
B 4 Screws, M6 X 30
C 15 Screws, M6 X 25
D 4 Cotter Pins
E 27 Hex Nuts, M6
F 23 Flat Washer, M6
G 4 Lock Washers, M6
H 4 Large Flat Washers
HARDWARE REFERENCE CHART
B
A
M6X30
M6X50
E
FIGURE 1
DESCRIPTION
D
C
M6X25
G
F
ENGLISH
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
(1) Screw Driver
(1) Pliers
(1) 10 mm Wrench
When assembling your cart, place the heads of all
screws to the inside and hex nuts with flat washers to
the outside.
1. Lay the front angle assembly down (flat) on floor and
stand the bottom panel in position as shown in figure
.
The bottom panel has one galvanized edge;
this is the rear. The front edge has three
holes. See figure 2.
2. Line up three holes in bottom panel with holes in front
angle assembly. Start three M6 x 25 screws through
bottom panel, then through angle. Secure screws with
Ф6 flat washers and M6 hex nuts. Tighten securely.
See figure 2.
M6
HEX
NUT
Ф6
FLAT
WASHER
H
FIGURE 2

NOTE
BOTTOM
PANEL
THREE
FRONT
HOLES
M6X25
ANGLE
SCREW
ASSEMBLY