Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
aSSEMBlY iNStrUCtioNS
toolS rEQUirED for aSSEMBlY
(2) 3/4" Wrenches
(2) 1/2" Wrenches
aSSEMBlY of SMartliNk PlatforM
1. Rotate the end plates attached to the tray assembly
down to a vertical position as shown in figure 1.
2. Remove the bolt and nylock nut from the front right
corner of the tray assembly. See figure 1.
3. Attach the lift handle catch (6) to the front holes of the
tray assembly using the bolt and nylock nut removed
in step 1. See figure 1.
4. Assemble four 5/16 x 3/4" hex bolts (9) and 5/16"
nylock nuts (14) to the four empty corners in the tray
assembly. See figure 1.
5. tighten all eight of the 5/16 x 3/4" hex bolts in the
corners of tray assembly.
PrE-aSSEMBlED NUt
14
6
6. Attach the hitch tubes (5) to the third hole from the
front of the tray assembly using two 5/16 x 1" hex
bolts (11) and 5/16" nylock nuts (14). Do not tighten
yet. See figure 2.
11
PrE-aSSEMBlED Bolt
9
fiGUrE 1
11
5
14
14
5
fiGUrE 2
7. Secure the ends of the hitch tubes together using two
5/16 x 2-1/2" hex bolts (8) and 5/16" nylock nuts (14).
Do not tighten yet. See figure 3.
8. Attach the lift tube assembly (2), the lift handle (3),
and the hitch tube (5) to the rear hole on the right
side of the tray using a 5/16 x 1-1/2" hex bolt (10) and
5/16" nylock nut (14). tighten the nut then loosen 1/2
turn. See figure 4.
9. Secure the top hole of the lift handle to the top hole
of the lift tube assembly with a 5/16" x 1" hex bolt (11)
and 5/16" nylock nut (14). tighten. See figure 4.
2
10
14
4
8
8
14
fiGUrE 3
14
11
5
3
fiGUrE 4
Publicité
Table des Matières
