Using The Heater - Domo DO7316M Mode D'emploi

DO7316M

USING THE HEATER

1. Make sure that the on/off button is switched off.
2. put the plug into a suited socket (grounded, no less than 13AMp).
3. Choose a function with the function knob:
Comfort: the heater will operate according to the set temperature.
ECO
Eco: the heater will automatically maintain a temperature that is
4°C below the set temperature, without changing the setting of the
temperature knob. this way you can easily save energy.
Anti-frost: the heater will keep the temperature of the surroundings
above the freezing point, to avoid pipe breakage.
4. switch on the heater with the on/off button and the light indicator will light up.
5. Now adjust the thermostat to set the desired room temperature.
turn the knob clockwise or counterclockwise to decrease or
increase the temperature.
6. When the room temperature reaches the set temperature, the
appliance will stop heating up.
7. the appliance will start operating again when the room
temperature drops at least 3°C below the set temperature.
CLEANING
• turn off the heater, unplug the appliance and let the heater cool down completely
before cleaning it.
• Never immerse the cord, plug and heater in water or another liquid. do not pour
any water or other liquid over the heater.
• use a vacuum cleaner to remove dust and lint from the metal grid of the heater.
• Wipe the heater with a dry cloth to remove dust and use a damp (not wet) cloth to
remove stains.
• do not use any detergents or abrasive cleaning products to clean the appliance as
this may damage the finish.
STORAGE
store the heater in a cool, dry place when it is not being used. use the original
packaging to store the appliance, to avoid dust and dirt from entering the heater.
42
max
min