Domo DO7316M Mode D'emploi page 41

Wall mount
Caution: Keep the appliance at a minimum distance of 0,60m (volume 3) from bath
tub or shower, as indicated in the drawing. A person who is in the bath tub or shower
should not be able to touch the appliance, the power cord or the control knobs.
1. drill 2 holes in the wall according to the picture and the following dimensions:
a=13.8cm and B=150cm.
2. use a hammer to fasten an anchor in each of the 2 holes and fix the upper wall
mounting bracket to the wall using the screws for wall mounting to screw it into
the 2 holes with anchors.
3. place the heater on the upper wall mounting bracket and draw the marks where
the 2 screws for the lower wall mounting support need to be placed.
4. Remove the heater from the wall and drill 2 holes on the marks that you just
made. use a hammer to fix an anchor in each of the 2 holes.
5. place the heater on the upper wall mounting bracket and fix the lower wall
mounting support to the wall by using the screws for wall mounting.
Volume2
Volume1
60cm
41
Volume3
DO7316M