Teac CR-H260i Mode D'emploi page 7

CAUTION
Read this before attempting any operations.
p Avoid placing the unit in direct sunlight or close to any
source of heat, such as a radiator, heater, open fireplace
or amplifier. Also avoid locations that are subject to vibra-
tions or exposed to excessive dust, cold or moisture.
p This unit consumes energy when in standby.
p Place the unit in a stable location near the audio system
that you will use.
p Be careful to avoid injury when moving the unit due to
its weight. Get someone to help you if necessary.
p The voltage supplied to the unit should match the volt-
age as printed on the rear panel. If you are in any doubt
regarding this matter, consult an electrician.
p As the unit could become warm during operation,
always leave sufficient space around it for ventilation.
When placing this unit, position it so that it is at least 20
cm (8") from walls and other devices in order to allow
good heat dissipation. When installing it in a rack, leave
at least 15 cm (6") open above the unit and 10 cm (4")
open behind it. DO NOT place anything, not even CDs,
CD-Rs, LP records or cassette tapes, on top of the unit.
p Do not open the body of the unit as this might result in
damage to the circuitry or cause electric shock. If a for-
eign object should get into the unit, contact your dealer
or TEAC service company.
p When removing the power plug from the wall outlet,
always pull directly on the plug; never yank on the cord.
p Depending on the electromagnetic waves of television
broadcasts, interference might appear on television
screens when this unit's power is on. This does not indi-
cate that this unit or the TV is malfunctioning. If this
occurs, turn this unit's power off.
DO NOT MOVE THE UNIT DURING PLAYBACK
During playback, the disc rotates at high speed. Do not lift
or move the unit during playback. Doing so may damage
the disc or the unit.
WHEN MOVING THIS UNIT
Always remove the disc before relocating or moving this
unit. Moving the unit with a disc inside could cause a
malfunction.
Maintenance
If the surface of the unit gets dirty, wipe it with a soft cloth
or use diluted mild liquid soap. Allow the surface of the
unit to dry completely before using.
B For safety, disconnect the power cord from the socket
before cleaning.
p Never spray liquid directly on this unit.
p Do not use thinner or alcohol as they could damage the
surface of the unit.
p Avoid allowing rubber or plastic materials to touch this
product for long periods of time, because they could
damage the cabinet.
7