Troubleshooting - Teac CR-H260i Mode D'emploi

If you experience a problem with this unit, please check
the following items before requesting service. If it still does
not operate correctly, contact the retailer where you pur-
chased the unit or TEAC customer support (See the back
cover for contact information).
General
The power will not turn on.
e Check that the power cord is completely plugged into
the power outlet.
No sound is output.
e Select the source using the SOURCE button.
e Check the connection to the speakers.
e Adjust the volume.
e Unplug headphones from the PHONES jack.
e If "MUTE" is displayed, press the MUTE button.
The sound is noisy.
e The unit is too close to a TV or similar device. Install
the unit away from such devices, or turn them off.
Remote control does not work.
e Press the STANDBY/ON button to turn the unit on.
e If the batteries are exhausted, change the batteries.
e Point the remote control at the front panel of the unit
from a distance of less than about 5 m (16 ft).
e Clear obstacles between the remote control and the
main unit.
e If a strong light is near the unit, turn it off.

Troubleshooting (1)

CD player
Will not play.
e Load a disc with the label side up.
e If the disc is dirty, clean the surface of the disc.
e If a blank CD-R/CD-RW has been loaded, load a
e This unit might not be able to play some CD-R/CD-RW
e You cannot play back unfinalized CD-R/RW discs with
Sound skips.
e Place the unit on a stable place to avoid vibrations
e If the disc is dirty, clean its surfaces.
e Do not use scratched, damaged or warped discs.
prerecorded disc.
discs depending on the disc quality and recording
conditions.
this unit. Finalize such a disc in the CD recorder you
used to create the disc and try again.
and shocks.
Continued on the next page
49
e