Installation Procedure; Important; Care And Cleaning - Toto TB100SF Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION PROCEDURE

1) Install the hot and cold water supply
nipples (1/2" NPT male, not sup-
plied) according to the provided
diagram.
IM PORTANT: Correct positioning of
the supply lines is critical to ensure
proper installation.
Thoroughly flush all supply lines
and shut off the water supply before
proceeding with installation.
2) Slide the escutcheon up onto the
body of the tub filler assembly.
Connect the hot (red) and cold (blue)
tub filler hoses to the correct water
supply nipples.
3) Pull up gently on the tub filler body, and
slide the mounting bracket around the
hoses and supply lines.
Lower the tub filler body down over the
mounting bracket. Secure the mounting
bracket to the floor with seven self-
tapping screws, using the provided screw
anchors if necessary.
1/2" NPT Nipple
3/8"-9/16"
Floor
(10-15 mm)
Surface
Cold Supply
Hot Supply
Tub
Escutcheon
Tub Filler
Hoses
Hot Supply
Cold Supply
Nipple
Nipple
Mounting
Tub Filler
Body
Self-
tapping
Screws
4
4) Secure the tub filler body to the
mounting bracket with the six pro-
vided machine screws.
Lower the escutcheon over the
mounting bracket.
5) Tighten the vacuum breaker onto the
tub filler diverter.
Install the regulator inside the short
nut on the handshower hose, with the
small o-ring facing upwards (see the
illustration to the right), and tighten
the handshower hose onto the vacuum
breaker.
6) Connect the handshower to the free
end of the handshower hose.
Bracket
7) Turn on water supply and check all connections for leaks. Test the tub filler and the
handshower for proper operation.
If the temperature control operates with the cold and hot switched, verify that the
supply hoses are connected to the proper supply lines.
Your new tub filler is designed for years of trouble-free performance. Keep
it looking new by cleaning it periodically with mild soap, rinsing thoroughly
with warm water and drying with a clean, soft cloth. Do not use abrasive
cleaners, steel wool or harsh chemicals, as these will dull the finish. Failure to
follow these instructions may void your warranty.
Installation Procedure (continued)
Regulator
Handshower Hose
CARE & CLEANING
5
Escutcheon
Machine
Screws
Vacuum
Breaker
Handshower
Hose
Handshower

Publicité

Table des Matières
loading

Table des Matières