Daily Use; Automatic Heat Up; Automatic Switch-Off; Power Function - AEG HK634200XB Notice D'utilisation

4. DAILY USE

4.1 Activation and
deactivation
Touch
activate the appliance.
The control panel comes on after you ac-
tivate the appliance and goes off after
you deactivate the appliance.
When the appliance is deactivated you
can see only
4.2 Automatic Switch Off
The function deactivates the appliance
automatically if:
• All cooking zones are deactivated (
).
• You do not set the heat setting after
you activate the appliance.
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, the cook-
ing zone must be cool.
• You use incorrect cookware. The sym-
bol
zone deactivates automatically after 2
minutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off
function:
•
,
•
-
•
— 4 hours
•
-

4.3 The heat setting

Touch
Touch
The display shows the heat setting.
for 1 second to activate or de-
sensor field.
comes on and the cooking
comes on and the appliance
- — 6 hours
— 5 hours
— 1.5 hours
to increase the heat setting.
to decrease the heat setting.
Touch and at the same time to
deactivate the cooking zone.

4.4 Automatic Heat Up

You can get a necessary heat setting in a
shorter time if you activate the Automat-
ic Heat Up function. This function sets
the highest heat setting for some time
(see the diagram), and then decreases to
the necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1.
Touch . The symbol
in the display.
2.
Immediately touch
comes on in the display.
3.
Immediately touch
again until the necessary heat set-
ting comes on. After 3 seconds
comes on in the display.
To stop the function, touch
11
10
9
8
7
6
5
4
3
2
1
0
1 2 3 4

4.5 Power function

The Power function makes more power
available to the induction cooking zones.
The Power function can be activated for
a limited period of time ( see Technical
Information chapter). After that, the in-
duction cooking zone automatically sets
back to highest heat setting. To activate,
touch , comes on. To deactivate,
change the heat setting.

4.6 Power management

The power management divides the
power between two cooking zones in a
ENGLISH
25
comes on
. The symbol
again and
.
5 6 7 8 9