Installation Instructions; Connection Cable - AEG HK634200XB Notice D'utilisation

comes on.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
error message that comes on.

8. INSTALLATION INSTRUCTIONS

WARNING!
Refer to the Safety chapters.
Before the installation
Before the installation of the appliance,
record the information below from the
rating plate. The rating plate is on the
bottom of the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
8.1 Built-in appliances
• Only use the built-in appliances after
you assemble the appliance into cor-
Problem Possible cause
There is an error in the
appliance because a
cookware boils dry. The
overheating protection
for the cooking zones
and the Automatic
Switch Off operate.
Make sure, you operated the appliance
correctly. If not the servicing by a cus-
tomer service technician or dealer will
not be free of charge, also during the
warranty period. The instructions about
the customer service and conditions of
guarantee are in the guarantee booklet.
rect built-in units and work surfaces
that align to the standards.

8.2 Connection cable

• The appliance is supplied with the
connection cable.
• Replace the damaged mains cable
with a special cable (type H05BB-F
Tmax 90°C; or higher). Speak to your
local Service Centre.
ENGLISH
Remedy
Deactivate the appliance.
Remove the hot cook-
ware. After, approximate-
ly 30 seconds, activate
the cooking zone again.
If the cookware was the
problem, the error mes-
sage goes out of the dis-
play, but the residual
heat indicator can stay.
Let the cookware be-
come sufficiently cool
and refer to "Cookware
for the induction cooking
zone" to see if your cook-
ware is compatible with
the appliance.
31