Reading The Values Of A Program - Kinetec Spectra Manuel D'utilisation

Use of the hand control
Reading the values of a program: example SPEED
Beginning
To stop the unit
To access the program mode
To change the program if necessary
To read the speed value
After 5 seconds or after pressing on another key
To exit and validate the selected program
Start the unit
Comments:
• The values shown in the 'Display' column are examples. They actually depend on the stored programs.
• The current movement parameters can be changed while using that program but no data will be stored in the original program.
See the programming mode (p 10) to modify programs.
GB
14
Keys to press
KINETEC
40 STOP
Program
70 WARMUP
PROGRAM
or
25 warmup
PROGRAM
Speed
PROGRAM
70 WARMUP
KINETEC
40 STOP
KINETEC
40 run
Display
Check if the hand control is not blocked
15 110
(See page 7).
1
The program number blinks.
110
3
To change the program if necessary.
90
3
Displays the speed value.
5
3
110
The current parameters have been recorded in
15 110 program 3.
The value change at the speed of the
15 110 movement.
Remarks