ROBBE MISTRAL 2.0 Manuel D'utilisation page 12

ENGLISH
Install the elevator with the enclosed M3x10
screws on the fuselage and insert the ele-
vator linkage into the drillhole of the rud-
derhorn. Make sure to carefully tighten the
screws, without putting too much pressure
on the surface.
Use the cover to seal the servoshaft. In order
to glue the cover to the frame of the shaft
use UHU Por or double-sided tape.
12
ASSEMBLY THE FUSELAGE
01
03
02
Check the length of the elevator linkage and,
if needed, adjust it by adjusting the length of
the clevis rods. The rudder should be placed
in neutral position during a 90°position of
the servohorn.
04
Twist one clevis onto the thread of the
rudder's rod. Again, please make sure that
the rudder is placed in neutral position du-
ring a 90°position of the servohorn. Correct
the length of the clevis rods, if needed.