ROBBE MISTRAL 2.0 Manuel D'utilisation page 14

ENGLISH
Connect the aileron rods to the rudder- and
servo horns (outer servo). Make sure that
the rudder is placed in neutral position du-
ring right-angled position of the servohorn. If
needed, adjust the rods.
ARF: Install the servo in the servo opening.
We recommend the use of a designated
servo frame. Use a wire to route the servo-
cable through the servo openings. The green
6-pole MPX plugsystem is used to connect
the fuselage.
ARF: Install the servo in the servo opening.
We recommend the use of a designated
servo frame. Use a wire to route the servo-
cable through the servo openings. The green
6-pole MPX plugsystem is used to connect
the fuselage.
14
ASSEMBLY THE WING
09
11
10
The linkage of the flaps is realized by a cross-
over connection through the surface of the
wing. Therefore the rod must initially be con-
nected to the bottom side of the flap servo
and routed through the upper side of the
wing in order to be connected with the flap`s
rudder horn. If the servo horn is positioned
in a right-angle (neutral position), the deflec-
tion of the flap should read approximately
15mm downwards.
12
Pay attention to a proper cable guide. Stash
the excessive length of the leads away in the
cable conduits.