ROBBE MISTRAL 2.0 Manuel D'utilisation page 11

Congratulation that you took the choice to purchase this Robbe RC model airplane, a very good
choice from our point of view.
We put a lot of attention to the overall quality of the airplane in terms of design, performance and
manufacturing quality. We used all of our experience designing and building high quality aircraft in
order to present you an exceptional product. We chose high grade material and looked after high
end accessories in order to ensure top level outcome in terms of function, performance and
durability of the product. We are open and offer all necessary support in case you should find any
problem with your airplane.
As you are well aware this is a technical product. Due to its nature it is required if not mandatory to
read the instruction manual completely. Please follow the steps to complete your model as descri-
bed. It will ensure that your model will turn out in the best possible way. Please also take notice and
good care about the warning messages at the end of the instruction manual. Knowing about them
ensures that you can operate the model in the safest possible manner keeping risk away from you
and other persons. Also ensure that you comply with the latest legislation in terms of flight safety.
We wish you all the best for building and especially operating your RC airplane. In case you have
any questions please contact us. We are driven to offer the best possible support at any time.
Span
Length
Flying weight
Wing area
Airfoil
ARF-Version
Motor
RO-Power 3522 (1000 kV)
ESC
RO-Control 6-80A
Servos
6x FS-155MG
Servo cables Appr. 2m
Multilock
MPX plugs 2 pair MPX plugs
4S LiPo 2000-2500mAh
Battery
11 x 8"
Propeller
Spinner
38mm
TX min. 5 Channels
RX min. 7 Channels
Glues 5min epoxy resin
UHU Por, Velcro tape
INTRODUCTION
SPECIFICATIONS
2000 mm
1170 mm
1780 g
37,95 dm²
RG-15 mod.
NEEDED ACCESSORIES
PNP-Version
RO-Power 3522 (1000 kV) built-in
RO-Control 6-80A
6x FS-155MG built-in
built-in
built-in
4S LiPo 2000-2500mAh
11 X 8" included
38mm included
min. 5 Channels
min. 7 Channels
5min epoxy resin
UHU Por, Velcro tape
ENGLISH
11