Place assembled unit in desired location. Fill
10.
base with water (26 gallons/98.4 liters) or
sand (approx. 360 lb./163 kg) and press plug
(14) in place.
IF USING SAND:
2 GAlloNs oF
ANTI-FReeZe Is
NoT ReQuIRed
WARNING!
do NoT leAve
AsseMBly uNATTeNded
WHeN eMpTy; IT MAy TIp
oveR.
WARNING!
TWo cApABle AdulTs
ReQuIRed FoR THIs
pRoceduRe. FAIluRe To
FolloW THIs WARNING
could ResulT IN
seRIous INjuRy ANd/oR
pRopeRTy dAMAGe.
14
NoTe:
cAuTIoN!
Add TWo GAlloNs (7.6
lITeRs) oF NoN-ToXIc
ANTIFReeZe IN suB-
FReeZING clIMATes.
11.
HEIGHT ADJUSTMENT
Rest unit on support table. Remove adjustment knobs (A)
and carriage bolts (B) to extend or retract backboard and rim.
Height adjustment from 7
1/2
' to 10'.
A
WARNING
Backboard
may rotate during
height adjustment.
WARNING
Do not adjust height of system
in upright position. System must
be in down position to adjust
MOVING SYSTEM
1. While holding pole, rotate
basketball system forward
until wheels engage with
ground.
2. Move basketball system to
desired location.
3. Carefully rotate basketball
system upright.
1
4. Reattach ground restraint and
2
check system for stability.
3
15
Attach height adjustment and
soving system label (15) to
front of pole as shown.
Regulation rim height is 10
feet (3.05 m).
cAuTIoN!
B
HeIGHT AdjusTMeNT
ANd MovING sysTeM
lABel (15) MusT NoT
oBsTRucT FAcToRy
ATTAcHed WARNING
200439
11/00
lABel.
15
(3.05 m)
10 feet