HemoCue Glucose 201 RT Manuel D'utilisation page 56

Guidance and manufacturer's declaration – Electromagnetic immunity
The HemoCue systems are intended for use in the electromagnetic environment specified below. The customer or
user of the HemoCue systems should assure that it is used in such an environment.
Immunity test IEC 60601 test level
Electrostatic ±6 kV contact
discharge (ESD)
IEC 61000-4-2 ±8 kV air
Electrical fast ±2 kV for power supply
transient/burst lines
IEC 61000-4-4 ±1 kV for input/output
lines
Surge ±1 kV differential mode
IEC 61000-4-5
Voltage dips, short <5 %U (>95 % dip in U)
interruptions and for a 0.5 cycle
voltage variations
on power supply 40 %U (60 % dip in U)
lines for 5 cycles
IEC 61000-4-11 70 %U (30 % dip in U)
for 25 cycles
<5 %U (>95 % dip in U)
for 5 seconds
For explanation of U see
NOTE 1.
Compliance level Electromagnetic environment – guidance
±6 kV contact Floors should be wood, concrete or cera-
mic tile. If floors are covered with synthetic
±8 kV air material, the relative humidity should be at
least 30 %.
2 kV for power Mains power quality should be that of a typi-
supply lines cal commercial or hospital environment.
±1 kV for input/
output lines
±1 kV differential Mains power quality should be that of a typi-
mode cal commercial or hospital environment.
<5 %U (>95 % dip Mains power quality should be that of a typi-
in U) for a 0.5 cycle cal commercial or hospital environment.
40 %U (60 % dip If the user of the HemoCue systems requires
in U) for 5 cycles continued operation during power mains
interruptions, it is recommended that the
70 %U (30 % dip HemoCue systems be powered from an unin-
in U) for 25 cycles terruptible power supply or a battery.
<5 %U (>95 % dip
in U) for 5 seconds
56