Operation; Getting Ready; Standby Mode - OHAUS Guardian 5000 Série Manuel D'utilisation

EN-16

2 OPERATION

2.1 Getting Ready

To get ready:
1. Plug the female end of the provided power cord into
PEM (G) on the rear side of the unit.
Note: For the 10x10-120V unit, this end of the power
cord is fixed to the rear side of the unit.
2. Plug the male end of the power cord into a matching
standard grounded outlet.
3. The unit will beep once and the screen will illuminate
with three displays:
a) The first will display the unit type (left) and the
software version (right).
The second will display the unit's electrical
b)
power (left) and frequency (right).
The third will be the unit's main operating
c)
screen.
Note: If the third screen is blank and the red
standby indicator (B) to the left of the screen is
illuminated, the unit is in standby mode.

2.2 Standby Mode

1. The rocker switch (I) on the right side of the unit
controls standby mode.
2. When the unit is switched off:
a) All heating and stirring functions will turn off.
b) The screen will be blank and the standby
indicator (B) to the left of the screen will be
illuminated.
If the heater temperature is above 40°C, the
hot top caution indicator will remain
illuminated as well as the current top plate
temperature and "HOT".
3. When the unit is switched on:
a) All heating and stirring functions will remain
off.
b) The main operating screen will return.
Previous heating and stirring settings will be
displayed.
c) The unit is ready for normal use.
Guardian 5000 Series