Turning Scale On/Off; Zero Operation - OHAUS Catapult 1000 Serie Manuel D'instructions

EN-4
2.3.2 Battery Installation (Optional)
Open the battery cover on the bottom of the scale and install three "C" size (LR14)
alkaline or rechargeable batteries into the compartment. Orient the batteries as
shown on the inside of the compartment. Close the battery cover.
NOTE: Batteries are not included.
CAUTION
proper disposal or recycling requirements in accordance with local laws
and regulations.
3. OPERATION

3.1 Turning Scale On/Off

To turn the scale on, press the ON/ZERO
test, momentarily displays the model/software version, and then enters the active
weighing mode.
To turn the scale off, press and hold ON/ZERO

3.2 Zero Operation

By pressing the ON/ZERO
additional mass, the
capacity of the scale is reached. When a container is used, the
may be used to simulate a Tare function. Additional mass may then be added as a
NET weight. When removing both the sample and container from the scale, a
negative value may be displayed. Zero the scale again before subsequent usage.
NOTE: The ON/ZERO
displayed values are within +2% of full capacity. Above 2%, the range is limited to
full capacity by subtraction.
Figure 2-2. Battery Installation
:
Do not dispose of used batteries in domestic waste. Follow the
Off
button, the scale display returns to zero. When adding
Off
ON/ZERO Button may be used repeatedly until the full
Off
button will perform a true zero setting function when
Catapult 1000 Series Scales
.
Off
button. The scale performs a display
Off
button until OFF is displayed.
Off
ON/ZERO button