Getting Started; Unpacking; Battery Installation; Battery Replacement - Yamaha AP-U70 Manuel De Configuration

GETTING STARTED

Unpacking

After unpacking, check that the following items are
supplied.
● Remote control
POWER
USB
PC
AUX1
AUX2
HALL JAZZ CHURCH
GAME MOVIE
VDD TEST
A B
MUTE VOLUME
● CD-ROM
The CD-ROM contains
the Application Software
and online help for
controlling this unit from
your computer.

Remote control operation range

USB
PC
AUX1
AUX2
VIRTUAL 5.I
CH
DIGITAL USB PCM D. DSP
PROLOGIC FM AM ST
VOL
DSP M U T E
2
E-
● Batteries (AA, R6, UM-3
type)
LIVE
● USB cable
ON/OFF
C
Remote control
sensor
Within
approximately
6 m (19.7 feet)

Battery installation

Since the remote control will be used for many of this unit's
control operations, you should begin by installing the
1
supplied batteries.
1
Turn the remote control over and remove the battery
compartment cover by sliding it in the direction of
the arrow.
2
Insert the batteries (AA, R6, UM-3 type) according to
the polarity markings on the inside of the battery
compartment.
3
Close the battery compartment cover.

Battery replacement

If you notice that the remote control must be used closer to
the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
● Use AA, R6, UM-3 batteries.
● Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
● Remove the batteries if the remote control is not to be used for
an extended period of time.
● If the batteries leak, dispose of them immediately. Avoid
touching the leaked material and avoid contact with clothing,
etc. Clean the battery compartment thoroughly before
installing new batteries.
Notes
● The area between the remote control and the main unit must
be clear of large obstacles.
● Do not expose the remote control sensor to strong lighting, in
particular, an inverter type fluorescent lamp; otherwise, the
remote control may not work properly. If necessary, position
the main unit away from direct lighting.
3
2