Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Ultra SR1250
3.3
Event LED
The front handset LED
at the upper left indicates the following:
18
•
Blinking fast: incoming call.
•
Blinking slow: intercom call or paging.
•
Blinking every 2 seconds: there are new event message in handset
(see second text line on the display).
3.4
Menu structure
The handset has an easy-to-use menu structure. Every menu opens a list
of options.
To open the main menu, press the menu key
is on and in standby mode.
Press the up
or down
15
4
you want. The instructions in this user guide show the key symbols and the
position number on the device overview. Then press the menu key
again to open other options or to confirm the setting that is displayed.
17
Exit menu or go up a menu level
Press escape key ESC
to go to the previous menu option.
3
You can press the ESC
key at any time to cancel and return to standby
3
mode.
4
Handset - settings and operation
The steps below show the key and display symbols and the
position numbers on the device overview.
4.1
Powering up (Set up mode)
At the first insertion of the battery or after a reset operation, the handset
shall enter the set up mode. The user should select the country for various
country dependent settings:
1. 'WELCOME' is shown.
2. Press
to go to the country setting menu.
17
3. Use
or
to select the country.
4
15
4. Press
to confirm.
17
5. Press
again to confirm or press the escape key ESC
17
to go back.
6. Use
or
to select the language
4
15
when the handset
17
key to scroll through to the menu option
7. Press
to confirm.
17
8. Enter the date and press
9. Enter the time and press
4.2
Switching the handset on/off
1. Press the on/off key
2. To switch off the handset, hold down the on/off key
than 5 seconds until the device switches off.
4.3
Menu language selection
The telephone has 14 menu languages, to set the language, proceed as
follows:
1. Press
.
17
2. Press
or
4
3. Press
to confirm.
17
4. Press
or
4
5. Press
to confirm.
17
•
The language setting appears in the display
6. Press
or
4
•
Press
to confirm.
17
4.4
Making calls
4.4.1
External calls
1. Press
.
14
•
The call symbol
2. When you hear the dialling tone, dial the telephone number you want.
•
The number appears in the display and is dialled.
3. To end the call, press
the handset on the base station.
4.4.2
Call preparation
1. Enter the telephone number you want to call.
2. To correct the number, press ESC
3
3. Press
.
14
•
The call symbol
Handset - settings and operation
to confirm.
17
to confirm.
17
until the display turn on.
6
repeatedly, select 'HS SETTINGS'.
15
repeatedly, select 'LANGUAGE'.
15
repeatedly, select the desired language.
15
appears in the display.
or (if auto hang-up is set on) replace
6
.
3
appears in the display.
for more
6
5
Publicité
Table des Matières
