Smeg SCM1 Mode D'emploi page 33

Machine a cafe automatique electronique encastree
Masquer les pouces Voir aussi pour SCM1:
Table des Matières

Publicité

20
10
22
13
I
4 - USO
L'erogazione è programmata in fabbrica ma se vogliamo arre-
starla in anticipo premiamo il tasto STOP (
NB: Se si sta eseguendo un doppio caffè e subito dopo l'erogazione
del primo manca l'acqua (il display visualizzerà "MANCA ACQUA")
occorre riempire il contenitore e ultimare sempre l'erogazione del
secondo caffè, premendo lo stesso tasto.
4.7 Consigli utili per fare il caffè
Per fare dei buoni caffè teniamo conto dei seguenti fattori:
• Utilizzare un caffè in grani di buona qualità.
• Regolare il macinino (già impostato in fabbrica) in modo che du-
rante l'infusione il caffè scenda nella tazza non a gocce, ma ne-
anche troppo rapidamente.
• Se il caffè è poco cremoso e chiaro, la macinatura è troppo gros-
sa o la temperatura troppo bassa.
In questo caso la macinatura dovrà essere più fine, ruotare quindi la manopola 13.
• Se il caffè è troppo nero e di gusto "bruciato" la macinatura è
troppo fine o la temperatura troppo alta.
In questo caso la macinatura dovrà essere più grossa, ruotare quindi la mano pola 13.
N.B.: se la manopola 13 arriva a fine corsa, non la si
deve forzare.
21
23
13
BER-146
GB
4 - USE
Pouring is factory set; to stop it press STOP (
).
N.B: If you are making two coffees and straight after the first
there is insufficient water (INSUFFICIENT WATER will be
displayed). Fill the container and always finish making the
second coffee, by pressing the same key.
4.7 Useful advice on how to make coffee
To make good cups of coffee, bear in mind the following:
• use a good quality coffee grind;
• adjust the machine so that the coffee pours into the cup smoothly;
not in drops and not too fast.
• If the coffee is not creamy enough or is too light, grinding is too
coarse or the temperature is too low.
In this case grinding must be coarser, therefore turn the knob 13.
• If the coffee is too black or has a "burnt" taste, grinding is too fine
or the temperature too high.
In this case grinding must be finer, therefore turn the knob 13.
N.B.: if knob 13 has been turned as far as it will go, do
not force it any further.
34
13
).

Publicité

Table des Matières
loading

Table des Matières