Technical Data; Hot Water Supply; Care Instructions - Breuer Aquamaxx 330 9260 Instructions De Montage

Technical Construction Requirements
1. Recommended minimum ceiling height 2250 mm
2. Installation on tiled walls
3. Pressure: (cold and hot water as equal as possible)
min.flow pressure = 2 bar
max.flow pressure = 5 bar
Flow pressure greater than 5 bar = pressure reducer
required
Tip:
Definition "flow pressure": pressure of the water
coming out of the pipes.
4. Connections:
"
1 /
2
5. Key dimension: 150 mm
(key dimension = distance between connection
point centre and the centres of the hot and cold
supply points)

6. Hot water supply:

a) a central hot water supply
b) an electronically controlled throughflow heater (24 KW)
c) a hot water storage tank (minimum capacity,
120 litres; use of shower for 15-20 min.)
Water supply temperature:
hot water max. temp.:
min. temp.:
optimum temp.: 65°C

Care instructions

The different surfaces of today's faucetes require a meticulous care and cleaning regime.
The following rules apply:

Regular cleaning prevents the build-up of lime-scale!

Use a purpose recommended cleaner.
Caution: Any cleaner containing acetic acid, hydrochloric acid, chlorine
bleach or formic acid can cause considerable damage!

Adhere to the respective manufacturers instructions for cleaning.

Rinse with cold water after each period of cleaning.

No abrasive cleaning agents (scouring pads, etc.)

Do not spray the cleaning agent directly on the product, but
apply with a cloth (this prevents the accumulations of detergent)

No high-temperature cleaning agents (steam cleaners)

Do not use or store chemical cleaners near the fittings. The
release of chemicals can damage the fittings.

Damaged surfaces facilitate the penetration and infiltration of
detergents under the chrome plating which will enhance the damage.
85°C
20°C higher than the desired
blended water temperature
- 5 -

Technical data

1. Measurements:
Height: 1105 mm
Width: 290 mm
Depth: 460 - 475 mm
2. Equipment:
– Chrome-plated brass basic frame
– Large shower head
– Handset
– Thermostat with a converter
3. Use at 3 bar flow pressure
Shower head: 9 l/min
Handset: 7 l/min
Tip:
The intensity for the individual user depends on the flow
pressure.
Technical data not guaranteed.
We reserve the right to make changes.
The nozzle on the hand / or head
!
shower need to be regularly in
order to prevent the build-up
of lime-scale on the nozzles.
By sweeping the back
of your hand or your
thumb over the nozzle.
Damage caused by
!
inadequate or improper
cleaning are covered by
the warranty conditions.