Applications - IMG STAGELINE LSE-10RG Mode D'emploi

2. if a defect might have occurred after a unit
GB
was dropped or suffered a similar acci-
dent,
3. if malfunctions occur.
In any case the units must be repaired by
skilled personnel.
G
For cleaning only use a dry, soft cloth;
never use water or chemicals.
G
No guarantee claims for the units and no
liability for any resulting personal damage
or material damage will be accepted if the
units are used for other purposes than
originally intended, if they are not expertly
installed, not correctly connected or oper-
ated, or if they are not repaired in an
expert way.
If the units are to be put out of
operation definitively, take them to
a local recycling plant for a dis-
posal which will not be harmful to
the environment.

3 Applications

The laser unit projects rotating light dot pat-
terns in red and green on a surface where
the light dots will keep converging and
diverging. The laser beams are either emit-
ted continuously or at an adjustable fre-
quency or they start flashing to the rhythm
of the music picked up via the integrated
microphone.
8
4 Installation and
Setting into Operation
Install the laser unit safely and expertly. The
person setting up the unit together with all
additional components (e. g. mirrors, pro-
jection surface) to create a laser system
becomes the legitimate manufacturer of this
system. Always observe the warning
notes in chapter 2.1.
WARNING 1. As the safety regulations
are different in each coun-
try, always observe the
regulations of the country
where the unit is operated.
2. If the laser unit is installed at a place
where people may walk or sit under it,
additionally secure it (e. g. by a safety
rope fixed to the mounting bracket; fas-
ten the safety rope in such a way that,
in the event of a fall, the maximum
falling distance of the spotlight will not
exceed 20 cm).
When setting up or suspending the laser
unit, always ensure a sufficient air circula-
tion during operation. Keep a minimum dis-
tance of 50 cm to any adjoining surfaces
and never cover the air vents of the hous-
ing.
1) For setting up the laser unit with the desk
stand (4), screw the stand into the
threaded jack on the lower side of the
unit.
Alternatively, suspend the unit via the
mounting bracket (5) from a suitable
place. To adjust the unit, slightly release
the locking screws (1), adjust the inclina-
tion and retighten the locking screws.
2) Connect the power supply unit provided
to the lateral jack DC 5 V (11) and to a
mains socket (230 V~/50 Hz).