Accessories; Recommended Cutting Equipment - Zenoah GZ381 Manuel D'utilisation

Masquer les pouces Voir aussi pour GZ381:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 124
Chainsaw without guide bar, saw chain and with empty
tanks, kg
2
Noise emissions
Sound power level, measured dB(A)
Sound power level, guaranteed L
3
Sound levels
Equivalent sound pressure level at the operator's ear,
dB(A)
Equivalent vibration levels, a
2
Front handle, m/s
2
Rear handle, m/s
Saw chain/guide bar
Recommended bar lengths, inch/cm
Usable cutting length, inch/cm
Pitch, inch/mm
Thickness of drive links, inch/mm
Type of drive sprocket/number of teeth
Saw chain speed at 133% of maximum engine power
speed, m/s.

Recommended cutting equipment

Chainsaw model Zenoah GZ381 has been evaluated for
safety according to EN-ISO 11681-2 (Machinery for
forestry - Portable chainsaw safety requirements and
testing) and fulfills the safety requirements when
equipped with the below listed guide bar and saw chain
combination(s).
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in .
2
Noise emissions in the environment measured as sound power (L
2000/14/EC.
3
Equivalent sound pressure level, according to ISO 22868, is calculated as the time-weighted energy total for
different sound pressure levels under various working conditions. Typical statistical dispersion for equivalent
sound pressure level is a standard deviation of 1 dB (A).
4
Equivalent vibration level, according to ISO 22867, is calculated as the time-weighted energy total for vibration
levels under various working conditions. Reported data for equivalent vibration level has a typical statistical
dispersion (standard deviation) of 1 m/s
38
dB(A)
WA
4
hveq

Accessories

2
.
GZ381
4,4
113
114
102
2,9
4,3
15/38
14/35
0,325 /8,25
0,050/1,3
Spur/7
23,1
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is defined by the
number of teeth (for example 10T). For solid guide bars
the nose radius is defined by the size of the nose radius.
For a given guide bar length, you may use a guide bar
with smaller nose radius than listed.
) in conformity with EC directive
WA
272 - 009 - 21.06.2021

Publicité

Table des Matières
loading

Table des Matières