Dometic WAECO CoolPower MPS50 Notice De Montage Et D'utilisation page 14

_MPS-50.book Seite 14 Montag, 10. Mai 2010 11:56 11
General safety instructions
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified person in
order to avoid a hazard.
Do not operate the device in wet or damp environments.
Maintenance and repair work may only be carried out by quali-
fied personnel who are familiar with the risks involved and the
relevant regulations.
2.2 Safety when installing the device
a Ensure that the device is standing firmly!
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
Take the precautions necessary to ensure that children cannot
interfere with operation.
Dangerous situations may occur which cannot be recognised by
children!
Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
For installation on boats
e
If electrical devices are incorrectly installed on boats, corrosion
damage might occur. Have the inverter installed by a specialist
(marine) electrician.
Electrical cables
e
If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
Do not pull on the cables.
Do not lay the 110 – 240 V~ mains cable and the 12/24 Vg
cable together in the same duct (ductwork).
Fasten the cables securely.
Lay the cables so that they cannot be tripped over or damaged.
14
CoolPower MPS50