Adjusting Head Angle; Adjusting Head Horizontally; Adjusting Specified Drill Depht - HOLZMANN MASCHINEN SB 3116RHN Mode D'emploi

13.2.3 Adjusting head angle

1. To adjust the Head angle to other than 90 degrees,
loosen the right Clamping Lever.
2. Pull out the Guide Pin and turn it 90 degrees so that it's
cross pin rests on top of the outlet.
3. Align the mark on the Column Guide with the Scale.
4. Once the Head is tilted to the desired angle, retighten
the Clamping Lever.
5. To return the Head to the 90 degree position, do these
procedures in reverse.

13.2.4 Adjusting head horizontally

1. Loosen the right-side Clamping Lever.
2. Turn the Moving Bar clockwise or counterclockwise until the desired position is reached.
3. Tighten the right-side Clamping Lever.

13.2.5 Adjusting specified drill depht

1. Secure the workpiece to the Table.
2. Mark the desired whole depth on the side of
the workpiece. Also view the depth indicator on
the Depth Stop Ring.
3. Loosen the Depth Lock Screw.
4. Turn the scale on the Depth Stop Ring to the
desired depth and retighten the Depth Lock
Screw.
5. Pull the Feed Knob (34) counterclockwise
until it drills the hole and stops at the set
depth.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
OPERATION
46
SB 3116RHN / SB 3116RMN