Assembly - HOLZMANN MASCHINEN SB 3116RHN Mode D'emploi

12.4

Assembly

To aid in assembly, refer to the upper assembly drawing as well as to the parts drawings at the
end of this manual. The machine assembly is shown on basis of the model SB 3116RHN.
1. Position the Base (B6) on a level and sturdy floor for mounting. Bolt the Base to the floor using
appropriate hardware (not supplied). Base holes will accommodate 7/16 inch bolts. Pull out the
Wire Stabilizer (B21) rod from the rear of the Base.
2. Place the Column Support (B4) on the Base, aligning the mounting holes.
3. Insert four large Hex Screws into the mounting holes and tighten with a wrench.
4. Insert the Column (B1) into the Column Support (B4) and secure with Screw.
5. Install the Table Support (B7), with attached table Arm, over the Column (B1) and slide it
down. Engage the gears onto the Rack. Tighten the Table Clamp.
6. Slide the Column Collar (B19) over and down the Column (B1) about 8 inches. Tighten Screw
(B11).
7. Place the Extend Arm into the Arm, and then the Table (B20) into the opening in the Extend
Arm.
The next step involves lifting the head assembly onto the Column. The head
assembly is heavy. Have someone help you lift this assembly into place!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N I N G
ASSEMBLY
42
SB 3116RHN / SB 3116RMN