Transport And Storage; Maintenance; Malfunctions; Technical Specifications - Bremshey Sport CONTROL-S Mode D'emploi

pulse measurement, always try to standardize the
measurement situation as accurately as possible;
start measuring at the same heart rate level as
precisely as possible.
To switch back to the main display by pressing
4.
RECOVERY.

TRANSPORT AND STORAGE

Please follow these instructions when carrying
and moving the equipment about, because lifting
it incorrectly may strain your back or risk other
accidents:
The device is easy to move by pushing along on the
integrated transport wheels. Tilt the device from
the front and push along the floor on the wheels at
the front support. We recommend that you use a
protective base when transporting the equipment.
To prevent the equipment malfunctioning, store in
a dry place with as little temperature variation as
possible and protected from dust.

MAINTENANCE

The equipment requires very little maintenance.
Check, however, from time-to-time that all screws
and nuts are tight.
•
After exercising, clean the equipment with a soft,
absorbent cloth. Do not use solvents. Sweat may
cause corrosion: we recommend therefore that you
protect all metal surfaces outside the plastic covers
with teflon.
•
Never remove the equipment's protective casing.
CHANGING BATTERIES
The console gives a warning signal before the
change of batteries is due. Detach the lid of the
battery casing at the back of the meter and remove
the old batteries. Place the new batteries in the
holder (2 x 1.5 V AA) and push the battery casing
lid back into place.

MALFUNCTIONS

Despite continuous quality control, defects
NOTE!
and malfunctions caused by individual components
may occur in the equipment. In most cases it's
unnecessary to take the whole device in for repair,
as it's usually sufficient to replace the defective
part. Always give the model, serial number of
your equipment and in case of malfunctions also
conditions of use, nature of malfunction and any
error code.
When you encounter unusual behavior from the
device, contact your local Bremshey dealer for
service.
1 0
If you require spare parts, always give the model,
serial number of your equipment and the spare
part number for the part you need. The spare part
list is at the back of this manual. Use only spare
parts mentioned in the spare part list.

TECHNICAL SPECIFICATIONS

Length.............. ......................................... 128 cm
Width .............. ........................................ 57 cm
Height............. .......................................... 175 cm
Weight............. ......................................... 49 kg
The Control meets the requirements of the EU's
EMC Directives on electromagnetic compatibility
(89/336/EEC). This product therefore carries the
CE label.
The Control meets EN precision and safety
standards (EN-957).
Due to our continuous policy of product
development, Bremshey reserves the right to
change specifications without notice.
The instructions must be followed carefully
NOTE!
in the assembly, use and maintenance of your
equipment. The warranty does not cover damage
due to negligence of the assembly, adjustment
and maintenance instructions described herein.
Changes or modifications not expressly approved
by Bremshey will void the user's authority to
operate the equipment!
We wish you many enjoyable trainings!