Whirlpool IDC875SSS0 Instructions D'installation page 19

Gas pressure regulator
4. Remove the access cap by using a wrench, turning the
access cap counterclockwise.
5. Remove spring retainer from the cap by pushing against the
flat side of the spring retainer. Look at the spring retainer to
locate the "LP" or "NAT" position.
6. Turn over the spring retainer so the "NAT" is showing on the
bottom.
7. Snap the spring retainer back into the cap.
8. Reinstall the cap onto the regulator.
LP
E
D
A. Access cap
B. Gasket
C. Gas pressure regulator
To Convert Standard Surface Burners
1. Remove burner cap.
2. Remove burner base.
3. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A. Orifice spud
A
B
C
D. Spring retainer NAT position
E. Spring retainer LP position
A
4. Gas orifice spuds are stamped with a number on the side.
Replace the LP gas orifice spud with the correct Natural gas
orifice spud.
A. Stamped number
Refer to the following chart for the correct Natural gas orifice
spud placement.
Natural Gas Orifice Spud Chart for Standard Surface Burners
Burner Location Burner Rating
Right front 3,5000 Btu/h
Left front 6,000 Btu/h
Center 11,000 Btu/h
Right rear 6,000 Btu/h
Left rear 10,000 Btu/h
5. Place LP gas orifice spuds in plastic parts bag for future use
and keep with package containing literature.
6. Repeat steps 1-6 for the remaining burners.
7. Replace burner base, burner head and burner cap.
8. Place LP gas orifice spuds in plastic parts bag for future use
and keep with package containing literature.
9. Complete installation. See "Make Gas Connection" and
"Electronic Ignition System" sections.
Checking for proper cooktop burner flames is very important.
Natural gas flames do not have yellow tips.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner. See "Make Gas Connection" and
"Electronic Ignition System" section.
A
Size
0.90 mm
1.20 mm
1.55 mm
1.20 mm
1.50 mm
19