Make Gas Connection - Whirlpool IDC875SSS0 Instructions D'installation

3. Loosen (do not remove) the hex washer head screw and
insert the neutral (white) wire under the screw clamp at the
bottom of the center position terminal connector.
4. Insert the other 2 wires (lines 1 and 2) under the other 2 screw
clamps.
A
A. Insert wire under screw clamp.
B. Hex washer head screw
5. Securely tighten the hex washer head screws to
35 lbs-in. (4.0 N-m) minimum torque to make proper
electrical connection.
6. Tighten the locking ring of the conduit connector.
7. Replace the terminal block cover.
3-wire connection: Direct Wire
Use this method only if local codes permit connecting ground
conductor to neutral supply wire.
1. Loosen (do not remove) the hex washer head screws and
insert the neutral (white) wire under the screw clamp at the
bottom of the center position terminal connector.
C
B
A
A. Line 1
B. Ground-link
C. Hex washer head screw
D. Silver-colored terminal
block screw
2. Insert the other 2 wires (lines 1 and 2) under the other 2 screw
clamps.
A. Insert wire under screw clamp.
B. Hex washer head screw
3. Securely tighten the hex washer head screws to
35 lbs-in. (4.0 N-m) minimum torque to make a proper
electrical connection.
4. Tighten the locking ring of the conduit connector.
5. Replace the terminal block cover.
14
B
D
E
F
G
E. Neutral (white) wire
F. Line 2
G. UL listed conduit
connector and power
supply cable
B
A

Make Gas Connection

The gas pressure regulator is supplied with the Gas Connection
Kit. Check that all parts are included.
C
A
D
E
A. Joint
B. Pipe
C. Plate
1. Connect the gas pressure regulator to the pipe, using the
adapter.
C
A
A. Gas pressure regulator
B. Adapter
2. Securely attach the pipe and plate underneath the range,
using the screws provided.
A. Plate
B. Gas pressure regulator
C. Screws
A
B
D. Adapter
E. Gas pressure regulator
B
D
C. Plate
D. Pipe
A
C
B