Safety Devices Safety Devices; Two-Hand Operation; Operating The Machine; Electrical Connection - Stihl RLE 240 Manuel D'utilisation

Masquer les pouces Voir aussi pour RLE 240:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
9. Safety devices
The machine is equipped with several
safety devices for safe operation and for
the prevention of improper use.
Risk of injury!
If a safety device is found to be
defective, the machine must not be
operated. Consult a specialist
dealer; STIHL recommends STIHL
specialist dealers.
9.1 Safety devices
The scarifier is equipped with safety
devices which prevent inadvertent contact
with the blades/spring-tines and with
ejected scarified material.
These include the housing, grass catcher
box, discharge flap and correctly installed
handlebar.

9.2 Two-hand operation

The motor can only be switched on by
pressing and holding the ON button with
the right hand and then pulling the
motorstop lever to the handlebar with the
left hand.
38

10. Operating the machine

10.1 Electrical connection

Danger of electric shock!
Observe the safety instructions in
the section "For your safety" (
If using a cable drum, the
connection cord must be unwound
completely, otherwise electrical
resistance may cause loss of power
and overheating.
Only cables which are no lighter than the
following rubber sheathed cables may be
used as electric cables:
H07 RN-F DIN/VDE 0282
Minimum cross-section:
up to 25 m length: 1,5 mm²
up to 50 m length: 2,5 mm²
The connectors of the electric cables must
be made of rubber or have a rubber cover
and conform to the following standard:
DIN/VDE 0620
The mains voltage and mains frequency
must correspond to the information on the
rating plate and the information contained
in the section "Technical specifications"
(
17.).
The power cable must be adequately
protected by fuse (
17.).
This machine is intended for operation with
a power supply having a system
impedance of Z
at the transfer point
max
(house connection) of maximum
0,49 ohms (at 50 Hz).
The user must ensure that the machine is
only operated with a power supply which
meets this requirement. If necessary, this
information can be obtained from the local
electric power company.

10.2 Strain relief

During working, the strain relief
4.).
prevents any unintentional
disconnection of the electric cable and any
resulting damage to the mains connection
on the machine.
For this reason, the electric cable must be
fed through the strain relief.
● Form a loop in the power cable (1) and
guide it through the opening (2).
● Then push the loop over the hook (3)
and pull it tight.
10.3 Switching on the scarifier
Risk of injury!
Never tip the scarifier to switch on
the motor.
● 1 Press and hold down the ON
button (1).
● 2 Pull the motorstop lever (2) to the
handlebar and hold.
● The ON button (1) can be released
once the motorstop lever (2) is pulled.
● Scarify the lawn.
If the scarifying unit/aerator roller is
set to a low depth, the scarifier may
judder when starting.
10
11
0478 670 9908 B - EN

Publicité

Table des Matières
loading

Table des Matières