Komet KUB Centron Powerline Mode D'emploi page 27

Problems  possible causes  solutions
heavy wear on one side on centring spade
• tool not central  tool turret/holder may have shif-
ted – readjust machine
Withdrawal groove on one side
• tool not central  tool turret/holder may have shif-
ted – readjust machine
Fracture on external cutting edge
• feed rate too high  reduce feed rate
• interrupted cut  change to tougher insert grade
• cutting edge corner radius too small  use insert
with larger cutting edge radius
Bore too small/ too large
• machine not at X-0 position  move axis to correct
position
• machine axis shifted  readjust machine
Fracture on external cutting edge
• feed rate too high  reduce feed rate
• interrupted cut  change to tougher insert grade
• cutting edge corner radius too small  use insert
with larger cutting edge radius
Bore too small/ too large with adjustable tool
• wrong cutting edge radius used  use correct cut-
ting edge radius
• setting wrong  correct setting
ENGLISh
27