Komet KUB Centron Powerline Mode D'emploi page 25

1 2
7. Drilling a chamber
• Not possible
3
8. Starting on an edge
• Not possible
• Pre-machining required because of an undefined drilling
surface (spot facing, face milling)
• Then continue as described in point 1
9. Starting on a welded seam
• Reduce feed rate when starting bore
• Face beforehand if necessary
10. Drilling through stacked plates
• Not possible
11. Backing out of the bore
• Tool 9×D swings up at bore exit
• Back out of the bore with greatly reduced speed to avoid
any development of chatter marks
12. Adjustable
• Not adjustable, fixed diameter
• Intermediate dimensions on request
ENGLISh
Technical notes
25