Setting The Measuring Unit - Powerfix Profi HG02404 Instructions D'utilisation Et Consignes De Sécurité

The ultrasonic - transmitter / receiver
must point at the wall at a right
16
angle. Use the vial to do this
rect the product so that the air bubble
in the vial lies between the two marker
lines.
3. Press the READ button
ured distance appears in the display.
Note: Hold down the READ button
and move the product and move the
product further over the surface to be
measured. The product measures the
distance continuously. These are dis-
played in the display.
Setting the
measuring unit
You can choose between the measuring
units of metre (m) and foot ('...").
Measure a distance as described in
the section „Measuring distances".
As an example, „2m" will appear on
the display.
In order to set the measuring unit of
foot, proceed as described in step 1
to 3:
1. Press the MODE button
it pressed.
2. Press the READ button
keeping the MODE button pressed.
3. To set the measuring unit of foot re-
lease the READ button first, followed
by the MODE button. As an example,
"6'07"" will appear on the display if
you have measured a distance of 2 m.
: di-
8
. The meas-
6
and keep
4
while
6
GB/IE/NI 17