Before Start Of Operation; Insert / Replace Battery; Preparing The Calliper; Starting Up The Device - Powerfix Profi Z22855 Instructions D'utilisation Et Consignes De Sécurité

Before start of operation

Q

Insert / replace battery

Q
Tip: Flashing numbers indicate a discharged / flat battery.
Tip: When changing the battery, the LCD display
experience faults. Remove the battery and insert it again after
waiting more then 30 seconds.
j
Push open the lid to the battery compartment
j
Remove the old battery.
j
Insert the new battery into the battery compartment and
ensure correct polarity (+ and -). Make sure that the plus
terminal points outwards.
j
Push the lid to the battery compartment
Fig. B).

Preparing the calliper

Q
j
Loosen the locking screw
calliper.
j
Clean all measuring surfaces and the calliper rod. Otherwise,
faulty measuring results may occur due to, for example,
humidity.
j
Check that all keys, switches and the LCD display
correctly.

Starting up the device

Q

Using the calliper

Q
j
Loosen the locking screw
j
Push the external measuring jaws
measuring jaws
j
Switch the LCD display
j
Press the inch / mm key
(inch or mm) you wish to use. Either "mm" or "inch" will
appear to the right of the figures in the LCD display
j
Press the key to obtain the zero setting (ZERO)
to reset the LCD display
Measuring an object from the outside:
j
Move the external measuring jaws
handwheel
measuring jaws
j
Turn the handwheel
external measuring jaws
sides of the object you want to measure. Please ensure that
you do not damage the object you want to measure by
subjecting it to too much pressure.
together.
2
on by pressing the ON / OFF key
5
3
5
outwards anti-clockwise. Place the external
7
against the object to be measured.
11
inwards clockwise. Move the
7
11
so that you can move the
4
by turning it anti-clockwise.
4
and the internal
11
to set the unit of measurement
to zero.
apart by turning the
11
together until they touch both
may
5
(see Fig. B).
8
shut again (see
8
work
5
5
in order
9
GB/IE 9
.
10
.