Technical Information - Zanussi ZDT 13011 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
Limescale particles on the
dishes.
Whitish streaks and stains
or bluish layers on glasses
and dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and
matt.

Technical information

Dimensions
Electrical connection
Water supply pressure
26
Possible cause
Incorrect position of the items in the
baskets. Water could not wash all
items.
The spray arms could not turn freely.
The quantity of detergent was not
sufficient.
There was no detergent in the deter-
gent dispenser.
The salt container is empty.
The set level of the water softener is
incorrect.
The cap of the salt container is loose.
The released quantity of rinse aid is
too much.
The quantity of detergent was too
much.
The released quantity of rinse aid
was not sufficient .
The quality of the detergent can be
the cause.
The programme had no drying phase.
The rinse aid dispenser is empty.
The quality of the rinse aid can be the
cause.
Width / Height / Depth (mm)
Refer to the rating plate.
Voltage
Frequency
Min. / max. (bar / MPa)
Possible solution
Make sure that the position of the
items in the baskets is correct and that
the water can easily wash all items.
Make sure that the position of the
items in the baskets is correct and
does not cause the blockage of the
spray arms.
Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.
Make sure that you add detergent in
the dispenser before you start a pro-
gramme.
Make sure that there is dishwasher salt
in the salt container.
Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area.
Tighten the cap.
Decrease the released quantity of
rinse aid .
Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.
Increase the released quantity of rinse
aid.
Try a different brand of detergent.
Set a programme with the drying
phase.
Make sure that there is rinse aid in the
rinse aid dispenser.
Try a different brand of rinse aid.
596 / 818 - 898 / 550
(0.5 / 0.05 ) / (8 / 0.8 )
www.zanussi.com
220-240 V
50 Hz

Publicité

Table des Matières
loading

Table des Matières