Connection Example 2. To An Amp With Dolby Digital (Ac-3) Inputs - Pioneer DVL-V888 Mode D'emploi

Connection example 2.
To an amp with Dolby Digital
(AC-3) input
¶
Connect this player's digital output PCM/∂ jack to the Dolby Digital input jack of an amplifier or a receiver with Dolby Digital
capability. Use coaxial digital output or optical digital output depending on the amplifier's or receiver's inputs.
¶
Connect this player's ∂RF output (for LD) jack to the Dolby Digital (AC-3) RF input jack on an amplifier or receiver with Dolby
Digital capability.
¶
Perform the settings in the "Digital output" section on page 70, making sure to select PCM/DOLBY DIGITAL. (When
shipped from factory, PCM/DOLBY DIGITAL is selected.)
¶
Digital output of LD analog audio is not possible, so also connect this players audio output jack and the amp audio input jack.
Note
indicates the use of separately sold cords.
Notes
Karaoke sound (mic sound, key control etc.) is not output as digital
sound. When using for karaoke,
Be sure to connect the DVD player's AUDIO OUT to the
amplifier's AUDIO IN.
Switch the amplifier's SIGNAL SELECT setting to ANALOG.
(When SIGNAL SELECT is set to AUTO, because digital sound
is given priority, the karaoke function cannot be used.)
Some DVD format discs feature copy protect. With this kind of
disc, when a sampling frequency of 96 kHz is selected, no signal
is output from the digital output (see page 61).
AV amplifier or AV receiver
enabling Dolby Digital (AC-3)
digital input and RF input in
the same function.
When playing a disc with this player, switch the
function to the connected input jack on the player.
In the case of diagram above, select LD/SAT
terminals.
Connecting the Player
67